|
|||||
|
Phone: 847-356-0566 Fax: 847-356-0747 E-Mail: sales@mmcontrol.com | |||||
Powers 1/4 DIN Chlorination Controller | |||||
| |||||
Model 555 1/4 Chlorination Controller |
555 Spec Sheet |
Request More Information |
|||
 Powers 555 |
|
||||
Benefits & FeaturesThe 555 1/4 DIN Chlorination Controller provides the water and wastewater treatment industry an automatic and accurate means to control chlorine in potable and wastewater applications. The 555 can be easily set up to handle flow proportional control, residual control, compound loop control with lag times, and dechlorination with sulfur dioxide. Flow paced (or flow-proportioning) control positions a chlorine or sulfur dioxide valve in direct proportion to the water flow rate. For chlorine, a user-defined "dosage-setting" from 0% to 400% (the percentage of gas flow to water flow) increases or decreases the rate of gas feed dependent on water flow rate. Flow paced is well suited where the water flow rate varies but the disinfection/oxidation demand remains constant. Residual control positions a chlorine valve based on chlorine residual measurement. With a user defined residual setpoint, the 555 increases or decreases the gas feed dependent on deviation from setpoint. Residual control is ideal for applications where the water flow rate is constant but the disinfection/oxidation demand varies. Compound loop control positions a chlorine valve based on chlorine residual measurement and water flow measurement. The residual control signal trims the valve position signal generated by flow proportional control. Compound loop control is ideal for applications where water flow rate and disinfection/oxidation demand vary, or where tight control is required. Feed forward dechlorination control positions a valve (typically sulfur dioxide) in direct proportion to the water flow rate and residual level. With a user-defined "dosage-setting" from 0% to 400% (the percentage of gas flow to water flow) the 555 increases or decreases the rate of gas feed dependent on changes in residual level or water flow rate. |
|||||
| Can't find what you are looking for?
| |||||
|
* * * 800-876-0036 * * * Phone: 847-356-0566 Fax: 847-356-0747 E-Mail: sales@mmcontrol.com | |||||
WARNING: Some of the products we sell can expose you to chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Contact your sales rep or go to www.P65Warnings.ca.gov for more information.
All registered trademarks are fully acknowledged by: M&M Control Service, Inc.
M&M Control Service, Inc. does not represent or claim any affiliation, association, connection or approvals with or from any manufacturer unless stated. We fully acknowledge all trademarks and/or names which are pictured and/or listed throughout the M&M Control Service, Inc. Website.
(PowersTM, also known as, POWERS REGULATOR, MCC POWERS, POWERS-FIAT, POWERS PROCESS CONTROLS, CRANE POWERS and POWERS, a Watts Industries Company. The POWERS trademark is owned by Powers, A Division of Watts Water Technologies, Inc. M&M Control Service, Inc. Is a Stocking Distributor for PowersTM)
(All names unintentionally excluded from this list will be included in the next revision upon our notification.)
*This list may vary, as names not appearing on this list are entitled to the acknowledgment of their Trademarks by M&M Control Service, Inc.
Copyright 2024 M&M Control Service Inc., All Rights Reserved