HOW TO
IDENTIFY FIREYE CONTROLS
Beginning January 1976 Fireye adopted the
US national standard date coding for all units
whereby the first two digits identify the year and
the second two digits identify the week of the year.
Example 9212 = twelfth week of 1992.
"M" Series
Controls
UVM, TFM Controls have their date code stamped on
the side of the chassis.
M-II Series and MicroM
Series Controls
Both the M-II and MicroM Series Controls have the
model number printed on a label located on the
chassis, amplifier and programmer. The date code,
serial number and engineering codes are printed on a
label on the chassis. The date code and engineering
code are stamped on the underside of the printed
circuit board on the programmer and amplifiers.
"D" Series
Controls
D-Series Chassis Controls (70D10/, 70D20/21, 70D30 &
70D40/41) have date code, engineering code, and
model number stamped on the control. Model number
appears on chassis board under top end of the
chassis and on a label on the black plastic rear
cover of the chassis. D-Series Amplifiers and Pro-grammers
have their model numbers in the lower right hand
corner as you look at the covered side. Their date
code is just opposite the model number but on the
uncovered side of the circuit board.
Flame-Monitor Controls
Flame-Monitor Chassis (EB700, EB720, EB721) have the
model number, date code, and engineering code
stamped on the bottom of the chassis. Flame-Monitor
Amplifiers and pro-grammers have their model number
printed on a label located on the upper left hand
corner tab. Their date code and engi-neering code
appear on the uncovered side of the printed cir-cuit
board.
"P" Series Controls
Types 25RU8, 25SU5, 26RJ8, 26SJ5, 29RF5 have chassis
labels which identify the type, model, code and
serial numbers. Should code and serial numbers not
appear on the chassis label, they will be found
metal-stamped into: the bottom handle of the control
and on the Metal barrier on the frame just below the
terminal board. The serial number indicates the date
of manufacture.
Note: Black
print on a red label and red print on a white label
will always identify an FR control.
"C" Series Controls
Types 24CJ5, 25CU6, 25DU4, 26CF6 have chassis labels
located on the top of the amplifier that identify
the control as to type and model. The code and
serial numbers appear stamped on left side of
control and stamped on front of the control just
above or below the timer motor. The serial number
for "C" Series controls is coded as follows: "72B"
indicates February 1972 unit, "71D" indicates April
1971 unit.
Factory Trade-In
The following Fireye control models are acceptable
as trade-in toward the purchase of any applicable
Fireye control at trade-in pricing from an
Authorized Primeline Distributor. (Refer to the
cur-rent price sheet CG-14 for part numbers with
trade-in pricing): C-Series, P-Series, M-Series,
M-Series II (Chassis and Program-mers only),
D-Series (Chassis, Programmer, Amplifier), and
Flame-Monitor (Chassis, Programmer, Amplifier). Used
Honey-well controls are also accepted towards
trade-in purchase of Fir-eye controls.
The only requirement is that the Honeywell control
be of the same type functionally as the desired new
Fireye control. Check with your local Fireye sales
office for further details.
IMPORTANT NOTICE
When replacing Honeywell controls with Fireye
controls, be sure to follow the wiring diagram
included with the Fireye unit. Fireye and Honeywell
controls are not directly interchangeable, external
wiring requirements are different.
